Knowledgebase: Product
Rail-DALI-DMX. Power cycle and fault conditions.
Posted by Wayne Howell on 27 August 2014 10:10 AM

Users who are more familiar with DMX512 than DALI can find the way DALI ballasts respond to power cycle or fault conditions confusing. A key difference between DMX512 and DALI is that DMX512 is continuously refreshing whereas DALI is not.

When A DMX512 fixture is power cycled it will immediately take the DMX512 level data. When a DALI ballast is power cycled it will go to a pre-programmed level called "POWER ON LEVEL". It will stay at that level until a new DALI level command is sent. DALI-Scope can be used to both read and programme the ballast's "POWER ON LEVEL".

When a DALI ballast detects a fault, such as a brown out of the DALI BUS POWER SUPPLY it will go to a pre-programmed level called "SYSTEM FAILURE LEVEL". It will stay at that level until a new DALI level command is sent. DALI-Scope can be used to read the ballast's "SYSTEM FAILURE LEVEL".


Help Desk Software by Kayako Fusion